Введение

Learn how to replace the PRAM battery in your Power Mac G5. The time and date, as well as other settings, are kept by the PRAM battery when your machine is off.

Инструменты

No tools required.

Запчасти

Никакие детали не требуются.

  1. To avoid electrocution, shut down the computer. Do not open the computer or attempt to install any items inside it while the computer is on.
    • To avoid electrocution, shut down the computer. Do not open the computer or attempt to install any items inside it while the computer is on.

    • To avoid being burned, wait at least 10 minutes to allow the computer's internal components to cool.

    Добавить комментарий

  2. Remove all the cables, including the power cables before opening the unit.
    • Remove all the cables, including the power cables before opening the unit.

    Добавить комментарий

    • Lift the tab to unlock the side panel.

    • The panel should fall out. If the panel does not fall out by itself pull a little from the edges.

    Добавить комментарий

  3. Free shipping on orders over $20
    Use code BLUEANDBLACK at checkout
    Free shipping on orders over $20
    Use code BLUEANDBLACK
    • Remove the air deflector (the clear plastic cover) by pulling on the handle.

    Добавить комментарий

    • Locate the battery inside the desktop.

    Добавить комментарий

    • Remove the battery by lifting the battery from the battery terminal.

    • Be careful to note which end is positive and which is negative. The positive end should be facing away from the PCI slots.

    • It is important to lift the battery as straight up as possible to avoid damage to battery or terminal.

    • The first photo shows the correct battery position. The last two photos show the battery facing the WRONG WAY! Remember, the positive end should be facing AWAY from the PCI slots, NOT towards them.

    why posting pictures of the wrong way to install it...

    maniaque37 - Ответить

    • The area should look like this after the battery is removed.

    • Be sure to properly dispose of the old battery after removal (take it to the nearest hazardous waste center).

    • Only insert LS1425OC 3.6V battery to prevent damage to the logic board.

    Добавить комментарий

Заключение

To reassemble your device, follow these instructions in reverse order.

29 участников успешно повторили данное руководство.

Nolan

Участник с: 13.01.2010

2 043 Репутация

Автор 2 руководств

Команда

Cal Poly, Team 5-8, Forte Winter 2010 Member of Cal Poly, Team 5-8, Forte Winter 2010

CPSU-FORTE-W10S5G8

7 членов

Автор 11 руководств

Комментариев: 5

plz advise the type of battery, thx !

adrianchan - Ответить

Thank you, very very instructive - but why on Earth

does Apple not mark the battry holder on this model

with + and - ? ? Now, thanks to your close-up photo

I found out which way to turn the battery. (I hope)

Best regards

Torben, Denmark

Torben Hellborn -

Agreed - slot should be marked with + and – . . .

Thanks for the clear and sharp photos d;-)

Andrew Lawes - Ответить

This is not valid for the late 2005 model of G5…Model 11,2.

It uses a coin shaped Panasonic Lithium battery. I just ordered one from OWC.

($.88)

Sari - Ответить

Grazie, molto utile! Alberto da Venezia

favarettostudio - Ответить

Добавить комментарий

Просмотр статистики:

За 24 часа: 12

За 7 дней: 56

За 30 дней: 345

За всё время: 61,931