Введение

Follow these steps to disassemble the plastic casing of the RIDGID R84015 X2 power drill.

Запчасти

Никакие детали не требуются.

  1. Remove the backplate.
    • Remove the backplate.

    • Using a Torx T20 screwdriver, remove the four screws attaching the back plate.

    Добавить комментарий

  2. Remove the drill handle.
    • Remove the drill handle.

    • Using the Phillips #2 screwdriver, remove the five screws attaching the drill handle to the body.

    Добавить комментарий

    • Remove the gear casing from the body.

    • Using the Philips #2 screwdriver, remove the four screws attaching the gear casing to the body.

    Добавить комментарий

  3. Free shipping on orders over $20
    Use code BLUEANDBLACK at checkout
    Free shipping on orders over $20
    Use code BLUEANDBLACK
    • With your drill taken apart, move your attention to the trigger and forward reverse switch.

    Добавить комментарий

    • Check to see that the forward reverse switch isn't broken.

    • NOTE: small tab on trigger fits into groove on forward reverse switch

    Добавить комментарий

    • With the battery attached, check that the wires work when the trigger is pulled.

    • Put multimeter wires here.

    • If wires work and drill doesn't, the problem is with the motor.

    Добавить комментарий

    • Make sure plastic is not broken and switch is not stuck.

    Добавить комментарий

    • Looks good, doesn't it?

    Добавить комментарий

Финишная черта

2 участников успешно повторили данное руководство.

Brian

Участник с: 12.04.2010

97 Репутация

1 Guide authored

Команда

Cal Poly, Team 15-48, Garner Spring 2010 Member of Cal Poly, Team 15-48, Garner Spring 2010

CPSU-GARNER-S10S15G48

6 членов

Автор 5 руководств

Один комментарий

I was able to diagnose and fix my problem with my black and decker following your instructions. TY

boxingchaos2011 - Ответить

Добавить комментарий

Просмотр статистики:

За 24 часа: 1

За 7 дней: 12

За 30 дней: 77

За всё время: 10,167