Samsung Rogue Front Function Keys Replacement

With your thumbs, push down on the back cover of your phone and slide it away from the camera.

You can now remove the battery by prying it up with your finger.

Use a plastic opening tool to carefully pry the back cover surrounding the camera up from the phone.

Remove the five 3.4mm Philips screws securing the backing of the phone.

Use a plastic opening tool to carefully pry off the back cover.

Remove the two 3.45 mm Philips screws below the white sticker.

Carefully lift the motherboard up from the bottom edge.

Use a plastic opening tool to disconnect the film from the motherboard.

Remove the eight 1.7mm Philips screws above the keyboard.

Carefully remove keyboard frame from the sliding mechanisms underneath.

Remove the five 3.0mm Philips screws around the outside of the sliding mechanisms.

Use a plastic opening tool to pry off the upper slide plate.

Use tweezers to open the two black gates by putting them in the "up" position.

With the same tweezers, carefully pull out the orange strips from the two specified gates.

Using tweezers, gently remove the bottom orange strip from the device.

At this point you can easily lift out the rubber function key pad as well.

There are two ways you can take out the front function keys:

1) Use a plastic phone opening tool to pry out the piece from the front of the phone.

2) Simply pop out the piece from the inside by pushing on its tabs.