Введение

This guide will provide a step-by-step procedure for replacing the keyboard in your Samsung Rogue.

Запчасти

Никакие детали не требуются.

Before disassembling your Samsung Rogue, make sure it is powered off. With your thumbs, push down on the back cover of your phone and slide it away from the camera.
  • Before disassembling your Samsung Rogue, make sure it is powered off.

  • With your thumbs, push down on the back cover of your phone and slide it away from the camera.

Добавить комментарий

You can now remove the battery by prying it up with your finger. You can now remove the battery by prying it up with your finger.
  • You can now remove the battery by prying it up with your finger.

Добавить комментарий

Use a plastic opening tool to carefully pry the back cover surrounding the camera up from the phone.
  • Use a plastic opening tool to carefully pry the back cover surrounding the camera up from the phone.

Добавить комментарий

Remove the five 3.4mm Philips screws securing the backing of the phone.
  • Remove the five 3.4mm Philips screws securing the backing of the phone.

Добавить комментарий

Use a plastic opening tool to carefully pry off the back cover. Make sure you are prying along the edge and not between the two halves of the phone that slide away from each other. Be careful to not drop the volume changing piece, for it can easily slip out.
  • Use a plastic opening tool to carefully pry off the back cover.

  • Make sure you are prying along the edge and not between the two halves of the phone that slide away from each other.

  • Be careful to not drop the volume changing piece, for it can easily slip out.

Добавить комментарий

Remove the two 3.45 mm Philips screws below the white sticker.
  • Remove the two 3.45 mm Philips screws below the white sticker.

Добавить комментарий

Carefully lift the motherboard up from the bottom edge. The film of wires is still attached to the motherboard, so do not completely remove the motherboard just yet or you may damage it.
  • Carefully lift the motherboard up from the bottom edge.

  • The film of wires is still attached to the motherboard, so do not completely remove the motherboard just yet or you may damage it.

Добавить комментарий

Use a plastic opening tool to disconnect the film from the motherboard. Use a plastic opening tool to disconnect the film from the motherboard.
  • Use a plastic opening tool to disconnect the film from the motherboard.

Добавить комментарий

Remove the eight 1.7mm Philips screws above the keyboard.
  • Remove the eight 1.7mm Philips screws above the keyboard.

Добавить комментарий

Carefully remove keyboard holder from the slider mechanisms underneath.
  • Carefully remove keyboard holder from the slider mechanisms underneath.

Добавить комментарий

Turn keyboard holder over and allow the keyboard to simply fall out into your hand. Turn keyboard holder over and allow the keyboard to simply fall out into your hand.
  • Turn keyboard holder over and allow the keyboard to simply fall out into your hand.

Добавить комментарий

Заключение

To reassemble your device, follow these instructions in reverse order.

Viktoria Mikoultchik

Member since: 15.04.2012

25 Репутация

Автор 14 руководств

Команда

Cal Poly, Team 7-32, Maness Spring 2012 Member of Cal Poly, Team 7-32, Maness Spring 2012

CPSU-MANESS-S12S7G32

4 членов

Автор 16 руководств

Комментариев: 0

Добавить комментарий

Просмотр статистики:

За 24 часа: 0

За 7 дней: 0

За 30 дней: 3

За всё время: 218