Введение

This guide will explain how to successfully remove the screen underneath the outside shell and on top of the circuit board.

Запчасти

Никакие детали не требуются.

  1. Remove 4 screws from bottom of camera Remove 2 screws from side of camera Remove 2 screws from side of camera
    • Remove 4 screws from bottom of camera

    • Remove 2 screws from side of camera

    • Remove 2 screws from side of camera

      • Place Screws on magnetic surface or location where they will not roll away

  2. Squeeze area noted by blue square and pull outside shell apart from remaining camera.
    • Squeeze area noted by blue square and pull outside shell apart from remaining camera.

  3. Free shipping on all orders over 100,00 $ or containing a Pro Tech Toolkit!

    Посмотрите наш магазин
  4. Remove two screws holding screen to circuit board marked by red circles
    • Remove two screws holding screen to circuit board marked by red circles

  5. Lift screen up such that orange circuit ribbon fully extends Flip white peg up noted by blue box Using tweezers gently remove orange circuit ribbon from white peg. Make sure white peg remains up otherwise ribbon may tear.
    • Lift screen up such that orange circuit ribbon fully extends

    • Flip white peg up noted by blue box

    • Using tweezers gently remove orange circuit ribbon from white peg. Make sure white peg remains up otherwise ribbon may tear.

Заключение

To reassemble your device, follow these instructions in reverse order.

One other person completed this guide.

Avinash Salgam

Участник с: 16.02.2014

597 Репутация

Автор 5 руководств

Комментариев: 0

Просмотр статистики:

За 24 часа: 0

За 7 дней: 0

За 30 дней: 6

За всё время: 329