Запчасти

Никакие детали не требуются.

Using a Phillips head screwdriver remove  six screws from the bottom of the console. The six screws are marked.
  • Using a Phillips head screwdriver remove six screws from the bottom of the console.

    • The six screws are marked.

Добавить комментарий

Remove the two screws that attach the Genesis' connector to the rest of the console.
  • Remove the two screws that attach the Genesis' connector to the rest of the console.

    • The two screws are marked in the diagram.

Добавить комментарий

Slide the lock tab to the left to separate the halves of the console.
  • Slide the lock tab to the left to separate the halves of the console.

Добавить комментарий

Lift from the left side to remove the top of the case.
  • Lift from the left side to remove the top of the case.

Добавить комментарий

Using the spudger, pry the cover off of the Genesis attachment.
  • Using the spudger, pry the cover off of the Genesis attachment.

Добавить комментарий

Lift the top of the case to remove the cover.
  • Lift the top of the case to remove the cover.

Добавить комментарий

Remove the faceplate by pulling it up, then out.
  • Remove the faceplate by pulling it up, then out.

Добавить комментарий

Remove metal plate by unscrewing the three screws with the Phillips head screwdriver and then lifting the plate. The three screws are shown on the diagram.
  • Remove metal plate by unscrewing the three screws with the Phillips head screwdriver and then lifting the plate.

    • The three screws are shown on the diagram.

Добавить комментарий

Remove the two screws from the plastic bar. The two screws are shown pictured.
  • Remove the two screws from the plastic bar.

    • The two screws are shown pictured.

Добавить комментарий

To remove the CD tray Remove the four screws with the Phillips head screwdriver.
  • To remove the CD tray

    • Remove the four screws with the Phillips head screwdriver.

Добавить комментарий

Carefully unplug the wire connected to optical reader.
  • Carefully unplug the wire connected to optical reader.

Добавить комментарий

Remove the four screws on the underside of the CD tray with a small Phillips head screwdriver. The four screws are highlighted on the diagram.
  • Remove the four screws on the underside of the CD tray with a small Phillips head screwdriver.

    • The four screws are highlighted on the diagram.

  • The four springs below the circuit board are attached to the screws, so be careful not to lose them when you remove the screws.

Добавить комментарий

Carefully remove the CD tray from circuit board.
  • Carefully remove the CD tray from circuit board.

Добавить комментарий

Заключение

To reassemble your device, follow these instructions in reverse order.

One other person completed this guide.

sskyllin

Member since: 18.10.2010

21 Репутация

Автор 2 руководств

Команда

Cal Poly, Team 5-14, Maness Fall 2010 Member of Cal Poly, Team 5-14, Maness Fall 2010

CPSU-MANESS-F10S5G14

5 членов

Автор 6 руководств

Комментариев: 0

Добавить комментарий

Просмотр статистики:

За 24 часа: 0

За 7 дней: 9

За 30 дней: 33

За всё время: 6,613