Введение

A bobbin is a small spool of thread that feeds the thread for the backside of the stitch. No sewing machine can sew without one. An incorrectly set up bobbin will create tangles in the thread. Bobbin setups vary from machine to machine. This guide shows the process for a Bernina 830, but the process will be similar for most sewing machines, except for those with drop-in bobbins. Refer to your sewing machine’s owner’s manual for specific directions on how to install a bobbin in your machine.

Инструменты

Запчасти

Никакие детали не требуются.

Use your finger to open the bobbin door below the presser foot. Use your finger to open the bobbin door below the presser foot.
  • Use your finger to open the bobbin door below the presser foot.

Добавить комментарий

Align the hole in the bobbin spindle over the peg in the bobbin case. Slide the bobbin into the bobbin case, leaving a bit of thread outside the case.
  • Align the hole in the bobbin spindle over the peg in the bobbin case.

  • Slide the bobbin into the bobbin case, leaving a bit of thread outside the case.

  • Take the loose thread end and slide it through the slit on the side of the bobbin case.

Добавить комментарий

Slide the thread from the slit straight up along the groove and into the open hole on  the bobbin case's side. Slide the thread from the slit straight up along the groove and into the open hole on  the bobbin case's side.
  • Slide the thread from the slit straight up along the groove and into the open hole on the bobbin case's side.

Добавить комментарий

Keeping the bobbin in place, turn the bobbin case so that the back is facing you. Use your fingernail to lift the lever on the back of the bobbin case. Hold the lever open.
  • Keeping the bobbin in place, turn the bobbin case so that the back is facing you.

  • Use your fingernail to lift the lever on the back of the bobbin case. Hold the lever open.

Добавить комментарий

Holding the bobbin case lever open, insert the bobbin case into the cavity under the presser foot. Align the metal arm on the bobbin case so that it sits in the slot in the machine.
  • Holding the bobbin case lever open, insert the bobbin case into the cavity under the presser foot.

  • Align the metal arm on the bobbin case so that it sits in the slot in the machine.

  • Release the bobbin case.

Добавить комментарий

Close the door on the compartment below the presser foot. Close the door on the compartment below the presser foot.
  • Close the door on the compartment below the presser foot.

You should leave a tail of thread sticking out of the compartment door. This creates tension and allows the bobbin thread to be pulled up correctly to the sewing surface. Once the bobbin thread is 'up', then you can put the table back in place.

jodyvalerie - Ответить

Finish Line

3 участников успешно повторили данное руководство.

Brittany McCrigler

Member since: 05.03.2012

78 143 Репутация

Автор 431 руководств

Команда

iFixit Member of iFixit

Community

115 членов

Автор 5 778 руководств

Комментариев: 0

Добавить комментарий

Просмотр статистики:

За 24 часа: 6

За 7 дней: 58

За 30 дней: 248

За всё время: 6,563