I am nee to soldering and know the basics. I replaced both joysticks with new TMR sticks with new Xbox joystick soldering tool. Replacement and soldering went well. But when I go to check controller with Xbox app, it connects but I can't move or use any part of controller. Any thoughts?
ΠΡΠΎ Ρ ΠΎΡΠΎΡΠΈΠΉ Π²ΠΎΠΏΡΠΎΡ?
Π Π΅ΠΏΡΡΠ°ΡΠΈΡ: 53,1ΠΊ
20
20
37
Hi!
Thanks for your comment!
Perhaps traces are damaged or the board went to hot.
Please check if everything is connected as it should and also for damaged traces.
Iβm afraid your motherboard did die or isnβt connected properly.
Can you check this? Thanks!
ΠΡΠ» Π»ΠΈ ΡΡΠΎΡ ΠΎΡΠ²Π΅Ρ ΠΏΠΎΠ»Π΅Π·Π΅Π½?
I will have to check for this a little later, but that may be the case. I'm wondering if I may have had too much heat when desoldering the original analog sticks. Thank you
That is possible yes... In this case you most likely want to replace the motherboard, but this isn't cheap...
ΠΠ° ΠΏΠΎΡΠ»Π΅Π΄Π½ΠΈΠ΅ 24 ΡΠ°ΡΠΎΠ²: 2
ΠΠ° ΠΏΠΎΡΠ»Π΅Π΄Π½ΠΈΠ΅ 7 Π΄Π½Π΅ΠΉ: 5
ΠΠ° ΠΏΠΎΡΠ»Π΅Π΄Π½ΠΈΠ΅ 30 Π΄Π½Π΅ΠΉ: 37
ΠΠ° Π²ΡΠ΅ Π²ΡΠ΅ΠΌΡ: 246
Hi!
Did you tried it here as well > https://hardwaretester.com/gamepad
What is working and what isn't?
ΠΈΠ· koppie007
Nothing works other than the controller turning on and connecting to xbox. I'd post a video if I could
ΠΈΠ· kmuetz