Возврат к шагу #3
Отредактированно Jeff Suovanen -
Правка одобрена автор Jeff Suovanen
- До
- После
- Без изменений
Шаг Линий
| + | [* icon_caution] Try to keep the adhesive strips flat and unwrinkled during this procedure; wrinkled strips will stick together and break instead of pulling out cleanly. |
|---|---|
| + | [* black] ***''Slowly''*** pull one battery adhesive tab away from the battery, toward the bottom of the iPhone. |
| + | [* black] Pull steadily, maintaining constant tension on the strip until it slips out from between the battery and the rear case. For best results, ***pull the strip at as low an angle as possible***, without snagging it on any of the iPhone's other components. |
| + | [* icon_note] The strip will stretch to many times its original length. Continue pulling and re-grab the strip near the battery if necessary. |
| + | [* black] If the battery adhesive tabs break during the removal process, use your fingers or blunt tweezers to retrieve the remaining length of adhesive, and continue pulling. |
| + | [* icon_caution] If any of the adhesive strips break underneath the battery and cannot be retrieved, try to remove the remaining strips, and then proceed as instructed below. |
Изображение 1
Нет предыдущего изображения
Добавлено
Изображение 2
Нет предыдущего изображения
Добавлено
Изображение 3
Нет предыдущего изображения
Добавлено