Возврат к шагу #8
Отредактированно Jeff Suovanen -
Правка одобрена автор Jeff Suovanen
- До
- После
- Без изменений
Шаг Линий
| + | [* black] If you successfully removed the entire ambient light sensor, as shown in the first photo, continue to the next step below. |
|---|---|
| + | [* black] If the white diffuser strip detached and remains embedded in the display, as shown in the second photo, you will need to carefully lever it out along the top edge using a thin blade or pry tool. Re-applying heat first may make this task a bit easier. |
| + | [* icon_reminder] During reassembly, install the diffuser into the display first, making sure it faces the right direction (the front-facing side is shown in the first image, and the rear-facing side is shown in the third). |
| + | [* icon_reminder] Then, set the ambient light sensor on top of the diffuser. You will need to hold the sensor in position while installing the screws securing the earpiece/sensor assembly. Once the screws are tightened, the sensor will stay in place and work normally. |
Изображение 1
Нет предыдущего изображения
Добавлено
Изображение 2
Нет предыдущего изображения
Добавлено
Изображение 3
Нет предыдущего изображения
Добавлено