Возврат к шагу #5
Отредактированно Dominik Schnabelrauch -
Правка одобрена автор Dominik Schnabelrauch
- До
- После
- Без изменений
Шаг Линий
| + | [* icon_caution] The removal procedure of the home button cover is a bit of a fumbling. Avoid damaging the home button flex cable. |
|---|---|
| + | [* black] Use a pair of tweezers and start to lift the home button cover on its left end. |
| + | [* black] Remove the home button cover by carefully pulling it towards the display flex cable. |
| + | [* icon_reminder] During reassembly, after installing the home button, you'll need to glue this bracket into place to secure it. |
| + | [* black] Scrape off as much of the old adhesive residue as you can, then clean it with acetone or high-concentration (90% or greater) isopropyl alcohol. |
| + | [* black] Secure the bracket with hot-melt glue, superglue, or [product|IF317-072-1|high-strength double-sided tape]. Make sure the bracket is aligned correctly before allowing your adhesive to cure, or the home button will not click when pressed. |
Изображение 1
Нет предыдущего изображения
Добавлено
Изображение 2
Нет предыдущего изображения
Добавлено
Изображение 3
Нет предыдущего изображения
Добавлено