Возврат к шагу #5
Отредактированно Adam O'Camb -
Правка одобрена автор Adam O'Camb
- До
- После
- Без изменений
Шаг Линий
| [* black] Peel away the clear backing from the camera bezel adhesive strip, exposing the adhesive on one side. | |
| [* black] Very carefully line up the rear camera and flash cutouts on inside of the rear glass with the same cutouts on the adhesive strip. | |
| [* black] Set the adhesive strip on the rear glass and make sure it does not overlap the edges of the camera or flash cutouts at all. | |
| - | [* black] |
| + | [* black] Use your fingers or the flat edge of a spudger to press the adhesive down so that it bonds to the glass. |
| [* black] Peel the green backing away from the adhesive strip. Make sure the adhesive does not come off of the glass with the backing. |