Возврат к шагу #1
Отредактированно Spencer Day -
Правка одобрена автор Spencer Day
- До
- После
- Без изменений
Шаг Линий
| [title] Unfasten the MagSafe port | |
| - | [* red] Use a |
| + | [* red] Use a 2IP Torx Plus driver to ***loosen*** the two set screws in the frame that align the MagSafe port. |
| [* icon_note] Don't remove these screws. Just loosen them a few turns above the frame. | |
| - | [* icon_note] Depending on the condition of your driver, a T3 Torx bit might fit best. |
| - | [* orange] Use your T5 Torx driver to remove the two 2.7 mm-long 5IP Torx Plus screws securing the MagSafe port. |
| + | [* orange] Use your T5 Torx driver to remove the two 2.7 mm-long screws securing the MagSafe port. |
| [* icon_note] These screws are not magnetic—be careful not to lose them. |