Перейти к основному содержанию

Возврат к шагу #7

Отредактированно Alex Diaz-Kokaisl -

Правка одобрена автор Alex Diaz-Kokaisl

До
После
Без изменений

Шаг Линий

[title] Remove the front panel assembly
[* black] Remove the front panel assembly.
[* icon_note] Use an opening pick to cut away any residual adhesive that may still be connecting the front panel assembly to the frame.
[* red] If you experience "ghost" or "phantom" touch input issues with your new display, this can be resolved by adding a layer of very thin insulating tape, such as [product|IF145-113-2|Kapton (polyimide) tape|new_window=true], to the highlighted areas on the back of the panel. ***iFixit replacement digitizers come with the proper insulation and should not require the addition of any tape.***
[* icon_note] Without the proper insulation, these areas of the digitizer can ground out against other components, causing touch input malfunction.
- [* icon_note] The insulation is not visible to the naked eye, and is different from the foam dust barrier strips found on many iPads.
+ [* icon_note] The insulation is not visible to the naked eye and is different from the foam dust barrier strips found on many iPads.
[* icon_reminder] During reassembly, before installing a display, remove any remaining adhesive from the iPad, and clean the glued areas with high concentration isopropyl alcohol (90% or greater) and a lint-free cloth. This helps prep the iPad for fresh adhesive and ensures that it will bond properly.
[* icon_reminder] Test your iPad's functions and install [product|IF419-005-1|pre-cut adhesive strips|new_window=true] to the back of the display using our [guide|118753|display adhesive application guide|new_window=true] before sealing it up.