Возврат к шагу #5
Отредактированно Sarah Westberg -
Правка одобрена автор Sarah Westberg
- До
- После
- Без изменений
Шаг Линий
| - | [* black] Once the ten remaining screws are removed, proceed to dislodge and remove the back panel. |
|---|---|
| - | [* icon_note] It may be helpful to use the Phillips #00 screwdriver to pry the back cover off, starting from the bottom edge |
| - | [* red] Also make sure to detach the camera film strip from the motherboard by using a pair of small tweezers to unhook the clip that is holding the strip. |
| + | [* black] Use a spudger to pry the back case off by working around the perimeter of the device, starting from the bottom of the 2DS. |
| + | [* icon_caution] Don't yank or pull the back case off because the camera ribbon is attached to the motherboard and back case and may rip or damage the cable or camera itself. |
| + | [* red] Use the tip of a spudger, an opening tool, or your fingernail to flip up the small, hinged locking flap on the [link|/%5Bhttps://www.ifixit.com/Guide/Recognizing+&+Disconnecting+Cable+Connectors/25629#s64969%7CZIF connector|camera cable|new_window=true]. |
| + | [* black] Use your spudger to gently slide the cable out of the connector. |
| + | [* black] Remove the back case. |