Возврат к шагу #11
Отредактированно Jeff Suovanen -
Правка одобрена автор Jeff Suovanen
- До
- После
- Без изменений
Шаг Линий
| - | [* black] Remove the card and |
|---|---|
| + | [* black] Remove the card and again slide it under the top edge of the battery, near the center. |
| [* icon_caution] Be extremely careful to slide the card ***over*** the front-facing camera and headphone jack cables to avoid cutting them. | |
| - | [* black] Lift up on the card to pry the battery up from the rear case. |
| + | [* black] Slide the card in as far as it will go, breaking through as much of the adhesive as you can. |
| + | [* black] Lift up on the card to pry the second battery cell up from the rear case. |
| [* icon_note] If there is significant resistance from the battery when you try to pry it up, reheat the adhesive with an iOpener and repeat the previous 3 steps to break apart the adhesive as necessary. |