Перейти к основному содержанию
/
Мой рабочий стол для верстки руководств

Получите быстрый доступ к руководствам, запчастям и ответам касательно ваших устройств

Возврат к шагу #3

Отредактированно Andrew Bookholt -

На одобрении

До
После
Без изменений

Шаг Линий

+[* black] If present, use a plastic opening tool to help remove the piece of tape covering the end of the dock connector cable.
+[* black] Use the edge of a plastic opening tool to carefully pry the dock connector cable's connector up from its socket on the logic board.
+[* black] Peel the dock connector ribbon cable off the rear panel.

Изображение 1

Нет предыдущего изображения

Добавлено