Возврат к шагу #4
Отредактированно Scott Havard -
Правка одобрена автор Scott Havard
- До
- После
- Без изменений
Шаг Линий
| - | [* icon_note] ***If this is your first time removing an iPhone battery adhesive strip, refer to the video in the following step before beginning.*** |
|---|---|
| - | [* icon_caution] Try to keep the strips flat and unwrinkled during this procedure; wrinkled strips will stick together and break instead of pulling out cleanly. |
| - | [* black] Slowly pull one battery adhesive tab away from the battery, toward the bottom of the iPhone. |
| - | [* black] Pull steadily, maintaining constant tension on the strip until it slips out from between the battery and the rear case. For best results, pull the strip at a 60º angle or less. |
| - | [* icon_note] The strip will stretch to many times its original length. Continue pulling and re-grab the strip near the battery if necessary. |
| + | [* black] Repeat the previous step for the second strip. |
| + | [* icon_caution] Hold down the battery as you remove the second strip, or the strip may fling the battery when it separates from the case. |
| + | [* black] ***If you removed both adhesive strips successfully, skip the next step. *** |
| + | [* black] Otherwise, if either of the adhesive strips broke off underneath the battery and could not be retrieved, ***continue with the next step below. *** |