Перейти к основному содержанию

Возврат к шагу #3

Редактировать с помощью Adam O'Camb -

Правка одобрена автор Adam O'Camb

Без изменений

Шаг Линий

[* black] Once the back panel is warm to the touch, apply a suction cup as close to the heated edge of the phone as you can while avoiding the curved edge.
[* icon_note] The suction cup will not make a good seal on the curved portion of the glass.
[* icon_note] If the phone's back cover is cracked, the suction cup may not stick. Try [https://d3nevzfk7ii3be.cloudfront.net/igi/4MmKE22Cy2MavVZU|lifting it with strong tape|new_window=true], or superglue the suction cup in place and allow it to cure so you can proceed.
[* black] Lift on the suction cup, and insert a halberd spudger, or opening pick, under the rear glass.
[* icon_note] Due to the curved glass, you will be pushing up, rather than inserting parallel to the plane of the phone.