Перейти к основному содержанию
Редактирование шага 2 —

Notice: You are editing a prerequisite guide. Any changes you make will affect all 15 guides that include this step.

Тип шага:

Перетащите чтобы изменить порядок

Insert a flat metal spudger in the gap between the rubber outer ring on the front panel assembly and the black plastic rear case near the USB connector.

Pry the front panel assembly up from the rear case, being careful not to damage the LCD or the glass panel.

As you work through the following steps, insert your metal spudger and pry the front panel up, but do not try to slide the spudger along the gap you're creating. Always remove your spudger, then insert it at another spot and pry upward.

Ваш вклад лицензируется под свободной лицензией Creative Commons.