Перейти к основному содержанию
Помощь
Редактирование шага 3 —

Notice: You are editing a prerequisite guide. Any changes you make will affect all 14 guides that include this step.

Тип шага:

Перетащите чтобы изменить порядок

Once the back panel is warm to the touch, apply a suction cup as close to the heated edge of the phone as you can while avoiding the curved edge.

The suction cup will not make a good seal on the curved portion of the glass.

If the phone's back cover is cracked, the suction cup may not stick. Try lifting it with strong tape, or superglue the suction cup in place and allow it to cure so you can proceed.

Lift on the suction cup, and insert a halberd spudger, or opening pick, under the rear glass.

Due to the curved glass, you will be pushing up, rather than inserting parallel to the plane of the phone.

Ваш вклад лицензируется под свободной лицензией Creative Commons.