Перейти к основному содержанию

Отремонтируйте ваше устройство

Обучение ремонту

Магазин

Введение

prereq for everything upper case

Запчасти

Детали не указаны.

  1. Remove the following screws securing the upper component cable bracket:
    • Remove the following screws securing the upper component cable bracket:

    • Two 2.0 mm Phillips screws

    • Three 1.4 mm Phillips screws

  2. Use tweezers to start peeling back the tape securing the upper component cable bracket. Use tweezers to start peeling back the tape securing the upper component cable bracket.
    • Use tweezers to start peeling back the tape securing the upper component cable bracket.

  3. Slowly peel the upper component cable bracket up out of the iPad—leaving the tape pieces on the bracket to make it easier to reinstall. Slowly peel the upper component cable bracket up out of the iPad—leaving the tape pieces on the bracket to make it easier to reinstall. Slowly peel the upper component cable bracket up out of the iPad—leaving the tape pieces on the bracket to make it easier to reinstall.
    • Slowly peel the upper component cable bracket up out of the iPad—leaving the tape pieces on the bracket to make it easier to reinstall.

Заключение

To reassemble your device, follow these instructions in reverse order.

Andrew Optimus Goldheart

Участник с: 17.10.2009

467 272 Репутация

Автор 410 руководств

Команда

iFixit Участник iFixit

Community

133 членов

Автор 14 600 руководств

Комментариев: 0

Добавить комментарий

Просмотр статистики:

За последние 24часов: 0

За последние 7 дней: 0

За последние 30 дней: 2

За всё время: 51