iPhone SE 2022 Home/Touch IDセンサーの交換

Английский

Японский

Требования для руководства

Все предварительные руководства должны быть переведены до того, как этот перевод будет считаться завершённым.

iPhone SE 2020 ペンタローブネジの交換

オープニング・ピックに3mmの印をつける

開口方法

バッテリーの接続の外し方

iPhone SE 2022 ディスプレイアセンブリの外し方

Информационный справочник

= Готово = Не завершен

Какую деталь вы заменяете?

Название

Введение

Use this guide to remove, transfer, or replace the home/touch ID sensor a.k.a the home button in an iPhone SE 2022.

This guide was performed on the ***A2783*** (international) model.

The iPhone SE 2022’s home “button” is actually a solid-state sensor, which also includes Touch ID (fingerprint recognition) capability.

***Most replacement home buttons won’t work***, so check carefully before starting your repair. Your iPhone’s original home button is uniquely paired to the logic board at the factory—and without Apple’s proprietary calibration process, even a genuine replacement home button from another iPhone won’t work. To fix a broken home button, you should install a specially-made, universal-style home button. Note that these replacements only work as a button and you'll loose Touch ID functionality.

If you are only replacing a broken screen, you can use this guide to carefully remove and transfer your working original home button to a new screen, preserving all functions, including Touch ID.

***Note:*** This guide instructs you to fully detach and remove the display assembly; this is highly recommended for easier handling and to prevent damage to the display cables. If you feel comfortable removing the Home/Touch ID Sensor while keeping the display cables attached, you can skip the steps for disconnecting the display.

If you do not replace the adhesive seals when reassembling, your device will function normally, but will most likely lose its water protection.

You’ll need replacement adhesive to reattach components when reassembling the device.

Заключение