iPhone SE 2022 バッテリーの交換

Требования для руководства

Все предварительные руководства должны быть переведены до того, как этот перевод будет считаться завершённым.

iPhone SE 2020 ペンタローブネジの交換

オープニング・ピックに3mmの印をつける

開口方法

バッテリーの接続の外し方

iPhone SE 2022 ディスプレイアセンブリの外し方

iPhone SE 2022 Wi-Fi ダイバーシティアンテナの交換

iPhone SE 2022 Taptic Engineの交換

Информационный справочник

= Готово = Не завершен

Английский

Японский

Какую деталь вы заменяете?

Название

Введение

Use this guide shows to remove and replace the battery in the iPhone SE 2022.

This guide was performed on the ***A2783*** (international) model.

If your battery is swollen, [[What to do with a swollen battery|take appropriate precautions|new_window=true]].

***For your safety, ''discharge your battery below 25%'' before disassembling your device.*** This reduces the risk of fire if the battery is accidentally damaged during the repair.

***Note:*** This guide instructs you to fully detach the display assembly; this is intended to prevent accidental damage to the display cables. If you feel comfortable removing the battery without putting undue strain on the display cables, you can skip the steps for detaching the display. Additionally, while it’s possible to remove the adhesive strips securing the battery as soon as you open the phone, this guide recommends first removing the Taptic Engine. Doing so reduces the risk of breaking the lower adhesive strips accidentally, either by snagging them on the Taptic Engine, or by pulling the strips at too sharp of an angle.

If you do not replace the adhesive seals when reassembling, your device will function normally, but will most likely lose its water protection.

You’ll need replacement adhesive to reattach components when reassembling the device.

Заключение