Ожидающие правки на Samsung Galaxy Watch4 Classic Battery Replacement

Примечание. Принятие или отклонение любого редактирования неявно применяется ко всем ранее ожидающим изменениям на том же этапе или введении.

Шаг #2 изменен: [Шаг изменён]

Отредактировано 18 янв 2025 г. на 123哆3 (73)

(У вас недостаточно репутации для патрулирования.)

Исходный текст

заголовок	Remove the battery
	0-black-Lift the battery up a little in order to access its glued down connector cable.
	0-black-Use a pair of [product\|IF145-020-4\|blunt tweezers] to lift up the battery connector which is secured with some light adhesive.
	1-icon_reminder-You will most likely be able to re-use the adhesive to fix the new battery in place. If not, replace it with [guide\|113604\|double sided or pre-cut adhesive tape\|new_window=true].
	0-black-Remove the battery.

+	[title] 取下电池
+	[* black] 轻轻抬起电池，以便接触到粘住的连接器线缆。
+	[* black] 使用[product\|IF145-020\|钝头镊子\|new_window=true]轻轻撬起通过轻粘合胶带固定的电池连接器。
+	[* icon_reminder] 您很可能可以重复使用原有粘合胶带将新电池固定到位。如果无法重复使用，请更换为[guide\|113604\|双面胶或预切粘合胶带\|new_window=true]。
+	[* black] 取下电池。

Шаг #1 изменен: [Шаг изменён]

Отредактировано 18 янв 2025 г. на 123哆3 (73)

(У вас недостаточно репутации для патрулирования.)

Исходный текст

заголовок	Lever up the battery
	0-icon_note-The battery is held in place with light adhesive.
	0-black-Place the flat end of a spudger in the small gap between the plastic frame and the battery, opposite to the display cable.
	0-black-Carefully lever the battery up and out of its recess.
	1-icon_caution-Take care not to puncture or bend the battery with your tool—a punctured or bent battery may leak dangerous chemicals or cause a thermal event.
	0-icon_caution-Don't try to remove the battery completely yet, as its connector is still adhered to the core assembly.

+	[title] 翘起电池
+	[* icon_note] 电池通过轻粘合剂固定到位。
+	[* black] 将撬棒的平端插入塑料框架与电池之间的小缝隙中，其位于显示屏排线的对侧。
+	[* black] 小心地撬起电池，将其从凹槽中取出。
+	[* icon_caution] 注意不要用工具刺穿或弯曲电池⸺刺穿或弯曲电池可能会泄漏危险化学物质或燃烧。
+	[* icon_caution] 不要急于完全取下电池，因为它的连接器仍然粘附在核心组件上。

Изменено введение

Отредактировано 18 янв 2025 г. на 123哆3 (73)

(У вас недостаточно репутации для патрулирования.)

Исходный текст

вещь	Battery
заголовок	Samsung Galaxy Watch4 Classic Battery Replacement
введение	Use this guide to replace a worn-out or dead battery in your Galaxy Watch4 Classic. If your battery is swollen, [[What to do with a swollen battery\|take appropriate precautions\|new_window=true]]. For your safety, *discharge your battery below 25%* before disassembling your Galaxy Watch4 Classic. This reduces the risk of a dangerous thermal event if the battery is accidentally damaged during the repair.
заключение	If possible, turn on your device and test your repair before installing new adhesive and resealing.[br] [br] Secure the new battery with pre-cut adhesive or double-sided adhesive tape. In order to position it correctly, apply the new adhesive into the device at the places where the old adhesive was located, not directly onto the battery. Press the new battery firmly into place.[br] [br] To reassemble your device, follow these instructions in reverse order. [br] [br] For optimal performance, *calibrate your newly installed battery*: Charge it to 100% and keep charging it for at least 2 more hours. Then use your device until it shuts off due to low battery. Finally, charge it uninterrupted to 100%.[br] [br] Take your e-waste to an [[E-Waste\|R2 or e-Stewards certified recycler\|new_window=true]].[br] [br] Repair didn’t go as planned? Try some [[Troubleshooting Problems After a Repair\|basic troubleshooting]], or ask our [link\|https://www.ifixit.com/Answers/Device/Samsung%20Galaxy%20Watch%204%20Classic\|Answers community] for help.

Thing

Title

Introduction

Conclusion