Ожидающие правки на iPhone 14 Rear-Facing Cameras Replacement
ZH
Примечание. Принятие или отклонение любого редактирования неявно применяется ко всем ранее ожидающим изменениям на том же этапе или введении.
|
заголовок
|
Remove the rear-facing camera assembly |
|
|
0-black-Use a pair of [product|IF145-020|tweezers] or your fingers to remove the rear-facing camera assembly. |
| + | [title] 移除后置镜头组 |
|---|
| + | [* black] 使用[product|IF145-020|镊子|new_window=true]或手指取出后置镜头组。 |
|---|
|
заголовок
|
Pry up the rear-facing camera assembly |
|
|
0-black-Insert the pointed end of a spudger underneath the top edge of the rear-facing camera assembly. |
|
|
0-black-Pry up with the spudger to loosen the rear-facing camera assembly. |
| + | [title] 挑起后置镜头组 |
|---|
| + | [* black] 将撬棒的尖端插入后置镜头组和机身顶部边框之间的缝隙中。 |
|---|
| + | [* black] 撬动撬棒，使后置镜头组松动。 |
|---|
|
заголовок
|
Remove the rear-facing camera assembly screws |
|
|
0-red-Use a Phillips screwdriver to remove the three 2.1 mm-long screws securing the rear camera assembly. |
| + | [title] 移除后置镜头组螺丝 |
|---|
| + | [* red] 使用十字螺丝刀，取下固定后置镜头组的3颗2.1mm长螺丝。 |
|---|
|
заголовок
|
Disconnect the rear-facing camera assembly |
|
|
0-black-Use a spudger to disconnect the two rear facing camera cables by prying the connectors straight up from their sockets. |
| + | [title] 断开后置镜头组的连接 |
|---|
| + | [* black] 使用撬棒将两个后置镜头与主板之间的接口从插槽中挑起，断开连接。 |
|---|
|
вещь
|
Rear-Facing Cameras |
|
заголовок
|
iPhone 14 Rear-Facing Cameras Replacement |
|
введение
|
Use this guide to replace the rear-facing cameras in your iPhone 14.
This guide was created using the ***A2882*** (international) model. If you're fixing a different iPhone 14 model, there may be some visual discrepancies, but the procedure should be the same.
***Note***: On iOS 18 and newer, you can calibrate new, genuine camera modules using Apple's [link|https://support.apple.com/en-us/120579|Repair Assistant|new_window=true].
You’ll need replacement adhesive to reattach the screen when reassembling the device. Your device will function normally, but will most likely lose its IP (Ingress Protection) rating. |
|
заключение
|
If possible, turn on your device and test your repair before installing new adhesive and resealing.
Compare your new replacement part to the original part—you may need to transfer remaining components or remove adhesive backings from the new part before installing.
***To reassemble your device, follow these instructions in reverse order.***
After your repair, depending on the replacement part, you may be able to [link|https://support.apple.com/en-us/120579|calibrate it using Apple's Repair Assistant|new_window=true], available as of iOS 18. Update your device, navigate to Settings ***→*** General ***→***About ***→*** Parts & Service History, tap Restart & Finish Repair, and follow the onscreen prompts.
Take your e-waste to an [[E-Waste|R2 or e-Stewards certified recycler|new_window=true]].
Repair didn’t go as planned? Try some [[Troubleshooting Problems After a Repair|basic troubleshooting]], or ask our [link|https://www.ifixit.com/Answers/Device/iPhone%2014|Answers community] for help. |
|
Thing |
|
|
Title |
|
|
Introduction |
| 参照本指南，为 iPhone 14 更换后置镜头组。 | | | 本指南以 *A2882* 国际机型为例。如果维修不同型号的 iPhone 14，部件外观可能略有差异，但维修步骤应当相同。 | | | ***注意：***在 iOS 18及更新版本中，可以使用 Apple 提供的[link|https://support.apple.com/en-us/120579|维修助理|new_window=true]工具校准更换的镜头组。 | | | 在重新组装设备时需要更换屏幕粘胶。设备功能不受影响，但无法保证维修后的防尘防水性能。 |
|
|
Conclusion |
| 如果可以，请先开机测试镜头组功能，再安装粘胶、粘合屏幕。 | | | 比较新旧零部件——可能需要将旧部件上的元件转移到新部件上，或移除粘胶保护膜，再将新部件安装到设备上。 | | | ***如要重新组装设备，请按照本指南的逆序操作。*** | | | 在完成维修后，取决于使用的替换部件，可以使用 [link|https://support.apple.com/en-us/120579|Apple 提供的维修助理工具进行校准|new_window=true]。该步骤适用于 iOS 18操作系统。请更新设备，然后前往设置 ***→*** 通用 ***→*** 关于 ***→*** 部件和维修记录，点击 重新启动并完成维修 选项，然后按照屏幕指引操作。 | | | 将电子废弃物携带至 [[E-Waste|R2 或 e-Stewards 认证回收点|new_window=true]]。 | | | 维修过程中遇到意外情况？尝试以下[[Troubleshooting Problems After a Repair|基础解决方案]]，或到 iFixit [link|https://www.ifixit.com/Answers/Device/iPhone%2014|问答社区]提问寻求帮助。 |
|