Перейти к основному содержанию

Возврат к шагу #7

Редактировать с помощью Arthur Shi -

Правка одобрена автор Arthur Shi

До
После
Без изменений

Шаг Линий

[* black] Insert the edge of an iPod opening tool under the steel mid plate near the bottom left corner of the Touch.
[* black] PrySlowly pry upward to separate the plate from the adhesive securing it to the plastic inner case.
[* blackred] If the plate is still attached to the logic boardboard, re-warm the area to loosen the adhesive, then slowly separate the plate from the logic board using the opening tool
[* icon_caution] Use extreme care, the speaker is under the area shown in photo. It is connected with very thin and short wires
tool.
[* orange] There is a very thinthin, fragile ribbon cable here that connectsunderneath the volume and power buttons toplate. As you pry the logic board. Try to work around this area like shown soplate up, be very careful not to rip the cable. Be sure to hold down this
[* icon_caution] This
cable when lifting the plate. It couldmay stick to the plate due to residual glue. It is extremely fragile. It is highlighted in a separate photo.
[* icon_caution] This cable
and will tear very easily if you areyou're not careful.
[* red] There is also adhesive under
Work slowly and be careful not to strain the area shown in redcable.
[* black] Insert the edge of an iPod opening tool under the steel mid plate near the bottom left corner of the Touch.
[* black] PrySlowly pry upward to separate the plate from the adhesive securing it to the plastic inner case.
[* blackred] If the plate is still attached to the logic boardboard, re-warm the area to loosen the adhesive, then slowly separate the plate from the logic board using the opening tool
[* icon_caution] Use extreme care, the speaker is under the area shown in photo. It is connected with very thin and short wires
tool.
[* orange] There is a very thinthin, fragile ribbon cable here that connectsunderneath the volume and power buttons toplate. As you pry the logic board. Try to work around this area like shown soplate up, be very careful not to rip the cable. Be sure to hold down this
[* icon_caution] This
cable when lifting the plate. It couldmay stick to the plate due to residual glue. It is extremely fragile. It is highlighted in a separate photo.
[* icon_caution] This cable
and will tear very easily if you areyou're not careful.
[* red] There is also adhesive under
Work slowly and be careful not to strain the area shown in redcable.