Перейти к основному содержанию

Reemplazo del panel frontal iPad 4G

Примечание: Вы редактируете необходимое руководство. Любые внесённые вами изменения влияют на все 153 руководства, которые включают этот шаг.

Английский
Испанский
Шаг 18
Removing iPad 3 4G Front Panel: шаг 0, изображение 1 из 3 Removing iPad 3 4G Front Panel: шаг 0, изображение 2 из 3 Removing iPad 3 4G Front Panel: шаг 0, изображение 3 из 3
  • Slide the opening pick along the top edge of the iPad, pulling it out slightly to go around the front-facing camera bracket.

  • The adhesive along this section is very thick, and a fair amount of force may be required. Work carefully and slowly, making sure to not slip and damage yourself or your iPad.

  • If the adhesive has cooled too much, replace the iOpener along the top edge and continue working. If the iOpener has cooled too much, reheat it.

  • If the opening pick is getting stuck in the adhesive, "roll" the pick as shown in step 9.

Desliza la púa de apertura a lo largo del borde superior del iPad, tirando ligeramente hacia fuera para rodear el soporte frontal de la cámara.

El adhesivo a lo largo de esta sección es muy grueso, y puede requerirse una cantidad justa de fuerza. Trabaja con cuidado y lentamente, asegurándose de no resbalar y dañarse a sí mismo o a tu iPad.

Si el adhesivo se ha enfriado demasiado, reemplace el iOpener a lo largo del borde superior y continúa trabajando. Si el iOpener se ha enfriado demasiado, vuelva a calentarlo.

Si la picadura de apertura está pegada en el adhesivo, "ruede" la selección como se muestra en el paso 9.

Ваш вклад лицензируется под свободной лицензией Creative Commons .