Перейти к основному содержанию

Notice: You are editing a prerequisite guide. Any changes you make will affect all 12 guides that include this step.

Английский
Японский
Step 14
Be careful not to touch any solder joints on the back of the power supply. Capacitors may be charged enough to give you a dangerous shock. Remove the following four screws:
  • Be careful not to touch any solder joints on the back of the power supply. Capacitors may be charged enough to give you a dangerous shock.

  • Remove the following four screws:

  • One 9.3 mm T10 coarse-threaded screw

  • One 25 mm T10 coarse-threaded screw

  • Two 22 mm fine-threaded screws

  • Pull the upper right and lower left corners of the power supply away from the rear case to dislodge the mounting posts attached to the power supply's corners.

次の4本のネジを外します。

9.3 mm T10 並目ネジー1本

25 mm T10 並目ネジー1本

22 mm 細目ネジー2本

電源の角に付けられた固定用ポストを外すには、リアケースから電源の右側上部と左側下部のコーナーを引き抜きます。

[* icon_caution] Be careful not to touch any solder joints on the back of the power supply. Capacitors may be charged enough to give you a dangerous shock.
[* black] Remove the following four screws:
[* red] One 9.3 mm T10 coarse-threaded screw
[* orange] One 25 mm T10 coarse-threaded screw
[* yellow] Two 22 mm fine-threaded screws
[* black] Pull the upper right and lower left corners of the power supply away from the rear case to dislodge the mounting posts attached to the power supply's corners.

Ваш вклад лицензируется под свободной лицензией Creative Commons.