I accidently broke one clip off, stopped to ponder and came up with a what i think is a nice solution: I went on and broke off the other clip. By doing so, i managed to create an clear path between both logic board screws to the right and left of the ram. then i went and found a thin plastic piece, which i cut to the correct rectangle size and drilled a couple of holes, one on each side. I then seated the ram in, pushed it down with the plastic rectangle, and screwed in the logic board screws to firmly hold the ram from jumping out. I DID have to use the longer fan screws since the originals in those places were too short for the added plastic width. I used the shorter screw on the fan instead. It works… and it’s pretty easy to do with a simple ruler, exacto knife, and a heated nail… (or more sophisticated tools if you have them).